416, 420, 426, 428, 430, 432, 436, 438, 442, 444 Series & more
The cutting edge is the primary wear part of the bucket, making direct contact with the ground. Its job is to protect the front of the bucket from wear and to ensure efficient digging and grading. If your bucket is leaving material behind, is unable to grade a surface precisely, and its leading edge is rounded, cracked, or worn down to the bucket's shell, it's time for a replacement. Continuing to operate with a worn cutting edge leads to irreversible damage to the bucket structure, which results in a very costly repair.
💪
HB400 Abrasion Resistant Steel
Maximum wear resistance
🔄
Reversible Design
Double the service life
🎯
Precision Mounting Holes
Stable and secure mounting
The accuracy and quality of materials guarantee long and trouble-free use without the need for frequent replacement.
A new cutting edge is the cheapest way to protect the much more expensive bucket structure from irreversible wear.
A sharp cutting edge restores the machine's factory performance, reducing work time and fuel consumption.
Plow bolts are single-use items. Always replace them with new ones of the correct strength grade (10.9 or higher).
Before mounting, carefully clean the mating surface on the bucket of any rust, dirt, and old cutting edge residue to ensure a perfect fit.
This is the most critical step! Tighten the nuts in a sequence from the center outwards and in a criss-cross pattern, to the torque specified in the service manual. Insufficient torque risks loosening, while excessive torque can shear the bolt.
After the first hour of operation, re-check and re-torque all bolts with a torque wrench.
Answer: Yes. A worn, "rounded" cutting edge is unable to grade a surface precisely. A new, sharp edge completely solves this problem.
Question: What does "reversible" mean?Answer: It means that after one cutting edge is worn, you can unbolt it, rotate it 180 degrees, and reinstall it, using the second, new edge. This effectively doubles its service life.
Question: What is HB400 steel?Answer: It is a high-quality, abrasion-resistant steel with a Brinell hardness of 400, commonly used in the production of earthmoving equipment. It is significantly more wear-resistant than standard structural steel.
If you are unsure whether the selected product is suitable for your machine, contact us and we will help you choose the right part and provide practical advice in minutes.
Data sheet
Specific References
Manufacturer
Responsible person
See also similar products



Toeplate / bolt 2406x203x19 suitable for CAT backhoe loaders

















