2CX, 2DX, 3CX, 4CX
Telescopic Handlers, FASTRAC
The axle shaft U-joint is a crucial pivot in the front drive axle that allows power to be transmitted to the wheels while steering. If you hear loud "popping", metallic clunking, or feel vibrations or squeaking while driving and turning, these are classic symptoms of a worn U-joint. Ignoring the problem leads to complete failure of the joint, which results in loss of drive to one wheel and damage to the much more expensive axle shaft yokes.
💪
Forged Steel Construction
Resistant to extreme loads
⚙️
Precision Bearings
Smooth operation, long life
🛡️
Effective Sealing
Protection from contaminants
The accuracy and quality of materials guarantee long and trouble-free use without the need for frequent replacement.
The U-joint is fully adapted to work with original axle shafts and yokes, ensuring a consistent and safe repair.
The NEXGEN brand is a proven and safe alternative that offers quality comparable to original parts at a much better price.
The U-joints on one axle wear at a similar rate. For even drive performance, it is recommended to replace both U-joints (left and right).
Before installing a new U-joint, carefully inspect the condition of the bores in the axle shaft yokes. If they are worn or oval, replacing the U-joint alone is a short-term solution.
Use a press and appropriate sleeves to press in the bearing caps. Hitting them with a hammer will damage the delicate needle bearings.
Regularly lubricating the U-joint through the grease nipple with high-quality grease, such as HYPTRON, is crucial for its longevity.
Answer: Yes, this is the main symptom. Loud noises on full lock while moving is a classic sign of worn needle bearings in the U-joint.
Question: Can I replace just one damaged bearing cap?Answer: No, the U-joint is a precisely matched set. It is always replaced as a whole, including all four new bearing caps.
Question: What is the main cause of U-joint failure?Answer: The most common causes are lack of regular lubrication, damaged seals allowing water and dirt into the bearings, and operating with play in the kingpins, which causes the joint to operate at an incorrect angle.
If you are unsure whether the selected product is suitable for your machine, contact us and we will help you choose the right part and provide practical advice in minutes.
Data sheet
Specific References
Manufacturer
Responsible person
See also similar products
Zazwyczaj kupuje części na Allegro, ale nie mogłem znaleźć krzyżaka półosi o tym wymiarze i znalazłem ten serwis. Muszę przyznać że będe tu wracać częściej.
Pozdrawiam






Kit-spider 82x30.2 suitable for JCB 3CX, telehandlers.

















